【7月末処分】3.5インチ 500GB SATA HDD：Seagate Barracuda 7200.12 ST3500418AS（投稿ID : 6r431）

自宅のストック処分です。 500GB SATA HDDです。 価格交渉可。 ノークレーム・ノーリターンでお願いします。 全セクタ0書き済み。 下記のS.M.A.R.T.データは、書き込み後のものです。 seatoolでの動作確認も問題ありませんでした。 === START OF INFORMATION SECTION === Model Family: Seagate Barracuda 7200.12 Device Model: ST3500418AS Serial Number: 6VMBPK5M LU WWN Device Id: 5 000c50 01f4efba9 Firmware Version: CC44 User Capacity: 500,107,862,016 bytes [500 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 7200 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Fri Jul 21 16:01:27 2017 JST ==> WARNING: A firmware update for this drive may be available, see the following Seagate web pages: http://knowledge.seagate.com/articles/en_US/FAQ/207931en http://knowledge.seagate.com/articles/en_US/FAQ/213891en SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 600) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 94) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 118 100 006 Pre-fail Always - 182888584 3 Spin_Up_Time 0x0003 097 097 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 20 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 100 253 030 Pre-fail Always - 83735 9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 2 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 20 183 Runtime_Bad_Block 0x0000 100 100 000 Old_age Offline - 0 184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 064 064 045 Old_age Always - 36 (Min/Max 24/36) 194 Temperature_Celsius 0x0022 036 040 000 Old_age Always - 36 (0 16 0 0 0) 195 Hardware_ECC_Recovered 0x001a 049 045 000 Old_age Always - 182888584 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 28 (178 147 0) 241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 1647829296 242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1425374075 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. root@ubuntu:~# ./st -l Drive information: /dev/sg1 ATA ST3500418AS CC44 976773167 blocks root@ubuntu:~# ./st -T 100 /dev/sg1 Drive /dev/sg1 does not support DST - generic long test will be run Starting generic long (full sequential verify) test (976773167 blocks) on drive /dev/sg1 (^C will abort test) Sequential Test 5 % complete on drive /dev/sg1 Sequential Test 10 % complete on drive /dev/sg1 Sequential Test 15 % complete on drive /dev/sg1 Sequential Test 20 % complete on drive /dev/sg1 Sequential Test 25 % complete on drive /dev/sg1 Sequential Test 30 % complete on drive /dev/sg1 Sequential Test 35 % complete on drive /dev/sg1 Sequential Test 40 % complete on drive /dev/sg1 Sequential Test 45 % complete on drive /dev/sg1 Sequential Test 50 % complete on drive /dev/sg1 Sequential Test 55 % complete on drive /dev/sg1 Sequential Test 60 % complete on drive /dev/sg1 Sequential Test 65 % complete on drive /dev/sg1 Sequential Test 70 % complete on drive /dev/sg1 Sequential Test 75 % complete on drive /dev/sg1 Sequential Test 80 % complete on drive /dev/sg1 Sequential Test 85 % complete on drive /dev/sg1 Sequential Test 90 % complete on drive /dev/sg1 Sequential Test 95 % complete on drive /dev/sg1 Generic Long Test PASSED on drive /dev/sg1