TOSHIBA DT01ACA100 (3.5HDD 1TB)（投稿ID : 1nyuhd）

1TBの3.5インチハードディスクです。 ノークレーム・ノーリターン、直接受け渡しのみでお願いします。 場所はダイソー津幡南店駐車場を希望します。 総合判定: PASSED 代替処理済み不良セクタ: Reallocated_Sector_Ct = 0 保留中セクタ: Current_Pending_Sector = 0 訂正不能セクタ: Offline_Uncorrectable = 0 CRCエラー: UDMA_CRC_Error_Count = 0 SMARTエラーログ: No Errors Logged Power_On_Hours = 9942　通電約 9942時間、約 414日 Start_Stop_Count = 4994 Load_Cycle_Count = 5009 $ sudo smartctl -i /dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-131-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Toshiba 3.5" DT01ACA... Desktop HDD Device Model: TOSHIBA DT01ACA100 Serial Number: Y9K86M1FS LU WWN Device Id: 5 000039 fded1d34d Firmware Version: MS2OA750 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Mar 25 07:08:52 2026 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled $ sudo smartctl -H /dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-131-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED $ sudo smartctl -a /dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-131-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Toshiba 3.5" DT01ACA... Desktop HDD Device Model: TOSHIBA DT01ACA100 Serial Number: Y9K86M1FS LU WWN Device Id: 5 000039 fded1d34d Firmware Version: MS2OA750 User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 7200 rpm Form Factor: 3.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 4 SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Mar 25 07:11:12 2026 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 7361) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 123) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0 2 Throughput_Performance 0x0005 141 141 054 Pre-fail Offline - 72 3 Spin_Up_Time 0x0007 136 136 024 Pre-fail Always - 169 (Average 167) 4 Start_Stop_Count 0x0012 099 099 000 Old_age Always - 4994 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 115 115 020 Pre-fail Offline - 34 9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 9942 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 2114 192 Power-Off_Retract_Count 0x0032 096 096 000 Old_age Always - 5009 193 Load_Cycle_Count 0x0012 096 096 000 Old_age Always - 5009 194 Temperature_Celsius 0x0002 222 222 000 Old_age Always - 27 (Min/Max 11/45) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.